6-70Printing Environment Settings6RESET Menu SettingsIMPORTANT• Data from PCL/UFR II Printer Driver cannot be output.• If you have output data, the data being printed is deleted. Print the data from thecomputer again.• When you are using an optional hard disk, set MODE TIMEOUT in the SETUPmenu to a setting other than OFF. It is recommended that you should specify thedefault setting, 15 seconds if possible.NOTE• The (Job) indicator is on when any print data remains in the printer memory orwhen no print data remains in the printer but a job has not yet been completed.• If MODE TIMEOUT for a job is specified, data less than one page is also outputautomatically when the specified time has elapsed (Data from PCL/UFR II PrinterDriver is not output.). MODE TIMEOUT for a job is set to 15 seconds in the defaultsettings.• If the (Job) indicator does not go off even after outputting the data, perform asoft reset. (See the previous item)SHUT DOWN-Shuts down the functions of the hard disk.If a hard disk is installed, the printer may be turned OFF during access to the harddisk when you turn the printer OFF. To prevent this accident, shut down thefunctions of the hard disk before turning the printer OFF.If you select SHUT DOWN in the RESET menu, the message that asks you if youexecute a shut down appears. Pressing [OK] at this point executes the shut down.After executing a shut down, the printer cannot receive data, and panel operationis disabled. Cycle the power of the printer if you want to print the data again.NOTEThis item is displayed only when an optional hard disk is installed, and HARD DISKis set to ON.
