|
8-33Message List8TroubleshootingMessage ListWhen the printer cannot continue printing for some reason (an error status), theprinter beeps, the (Message) indicator comes on, and an error message thatindicates the description of the error appears in the display. A Warning messageappears in the display when the printer requires some remedy (a warning status)although the job is not affected.If either of these messages appears, perform the following procedures according tothe message.NOTE• When multiple warnings are occurring at the same time, the Warning messages appearby rotation.• When the printer is in error status and warning status at the same time, the Warningmessage does not appear.• Even when a message with (Warning Message) appears (when the printer is in awarning status), the printer does not stop printing.• For a message with the mark, you can skip the error by pressing the(Online) key and continue printing. However, part of the print data may be missing orit may not be printed properly. When you want to stop the process, perform a soft reset toeliminate the cause of the error, press the (Online) key, and then print again. Also,you can automatically skip the errors to which this mark is attached by setting AUTOERROR SKIP in the SETUP menu to ON. ("n" represents a number)Cause A problem has occurred inside the printer.Remedy Solve the problem following the instructions in "Service Call Display" (See p.8-48).<02 COOLING>Cause 1 The temperature of the fixing unit exceeded a fixed value after printing(especially paper with a narrower width) continuously.Remedy Please wait a moment. The printer cools down the fixing unit automatically. Itresumes the job after finishing the cool down process.
|
