6-52Printing Environment Settings6SETUP Menu SettingsNOTE• You can check the adjusted printing position in PRNTPOSNPRINT (See p. 6-64) inthe UTILITY menu.• For adjusting the printing position, see "Adjusting the Printing Position," on p. 7-21.• Be aware that, when adjusting the printing position for 2-sided printing, theorientation of the images on the reverse pages varies depending on the printingorientation or setting for BIND.LOCATION (See p. 6-32).RECVRY PRINTINGON*, OFFSpecifies whether to print the partially printed page when the printer stops printingdue to a paper jam or an error occurring.If ON is specified for this item, the printer prints from the page in which a paperjam or error occurred.If OFF is specified for this item, the printer does not print from the partially printedpage but prints from the next page when a paper jam or error has occurred.When the printer is performing 2-sided printing, it does not print the reverse pageof the partially printed page. The printing starts from the front side of the nextsheet.SPECIAL MODE JOFF*, ONSpecifies whether the printer should stop printing, displaying the message <41CHK PAPER SZE> or continue printing when TRAY PAPER SIZE, CASSETTE1SIZE, or CASSETTE2 SIZE is set to MIXED SIZES.If OFF is specified, the printer may stop printing, displaying <41 CHK PAPERSZE>, when the paper size specified in the application is different from the size ofthe paper loaded in the multi-purpose tray or paper cassette. The paper on whichthe error occurred is output automatically. You can also continue printing bypressing the (Online) key. However, the data may not be printed properly, or apaper jam may occur.If ON is specified, the printer prints without performing a print check even whenthe paper size specified in the application is different from the size of the paperloaded in the multi-purpose tray or paper cassette. However, the printing speedmay drop. Also, because the paper is printed at the paper size specified in theapplication, blank areas may appear on the printed paper or part of the imagesmay be missing when the size of the paper loaded in the multi-purpose tray orpaper cassette is different from the paper size specified in the application.
