6-20Printing Environment Settings6SETUP Menu Settings• Saving print data on the hard disk (boxes) (data can be printed again) (See p.6-67)• Secured print (See p. 6-66)• Encrypted secured print (See p. 6-65)• RIP Once (See p. 6-21)• Spooler (See p. 6-49)• SMB printing (See p. 6-48)• Using SSL for communication by the Remote UI (See p. 6-49)Usually, leave the setting to ON. Specify OFF only when an error has occurred ina function that uses the hard disk.IMPORTANT• Initialize the SETUP menu after installing the optional hard disk, and then cycle thepower of the printer or perform a hard reset. After initializing the SETUP menu, thefunctions of the hard disk become effective by cycling the power of the printer orperforming a hard reset.• After changing the settings for this item, cycle the power of the printer or perform ahard reset to make the settings effective.NOTEThis item is displayed only when an optional hard disk is installed.INTERRUPT PRINTON*, OFFSpecifies whether to use the interrupt print function.NOTEThis item is displayed only when an optional hard disk is installed, and HARD DISKis set to ON. When HARD DISK is set to OFF, the setting for this item is ignored,and the interrupt print is disabled.SECURING TIME1 hour*, 2 hours, 3 hours, 6 hours, 12 hours, 24 hoursOn the computer, previously specify the time to delete data of "secured print" inwhich the file name, user name, and password are specified.Secured print data is saved on the hard disk, and normally, the data cannot bedeleted unless it is printed. However, the data is automatically deleted even if ithas not been printed when the time specified in this item has elapsed.NOTE• As well as secured print data, encrypted secured print data is also deleted whenthe time specified in this item has elapsed.
