6-56Printing Environment Settings6SETUP Menu SettingsUPDATE FIRMWARE■ USB-This item is to be executed only when the firmware of the printer needs to beupdated.■ NETWORK-This item is to be executed only when the firmware of the printer needs to beupdated.1ST CALIBRATIONAFTER JOBS*, IMMEDIATELYWhen you turn the printer ON, calibration is performed depending on the insidestate of the printer. Specify the timing of calibration.If AFTER JOBS is specified, calibration is performed at the completion of the firstprinting after the printer is turned ON.If IMMEDIATELY is specified, calibration is performed immediately after the printeris turned ON. When calibration is performed immediately after the printer is turnedON, excessive time is required until the printer is ready to print.PCL SETUP OptionsPAPER SAVEOFF*, ONSpecifies whether the printer outputs the blank page that can be created due tono data existing between two Form Feed codes sent from an application.If ON is specified, the printer does not output the blank page. If OFF is specified,the printer outputs the blank page.If you use this function, you can save paper because the blank pages are notoutput.
