6-51Printing Environment Settings6SETUP Menu SettingsEXT.RX BUFFEROFF*, ONIf this item is set to ON, the memory capacity of the printer's receive buffer thatreceives the data is increased. You can speed up the time the computer exitswhen you send a large amount of data or complicated data from the computer.IMPORTANTAfter changing the settings for this item, cycle the power of the printer to make thesettings effective.NOTEThis item is displayed only when an optional RAM module is installed.USER MAIN. OptionsADJ.START POS.OFFSET Y (TRAY) ................-5.0 to 5.0; 0.0* (mm)OFFSET X (TRAY)................-2.22 to 2.22; 0.00* (mm)OFFSET Y (CASS1) .............-5.0 to 5.0; 0.0* (mm)OFFSET X (CASS1) .............-2.22 to 2.22; 0.00* (mm)OFFSET Y (CASS2)*1 ..........-5.0 to 5.0; 0.0* (mm)OFFSET X (CASS2)*1 ..........-2.22 to 2.22; 0.00* (mm)OFFSET Y (DUP.) .................-5.0 to 5.0; 0.0* (mm)OFFSET X (DUP.).................-2.22 to 2.22; 0.00* (mm)*1 OFFSET Y (CASS2) and OFFSET X (CASS2) are displayed only when the optional paper feeder isinstalled.Specifies the printing position of the paper in the specified paper source. Adjuststhe position in the vertical direction (Y) or the horizontal direction (X) by thespecified value.The setting values are indicated in millimeters (mm), and you can adjust theposition using [ ] and [ ].If you do not adjust the printing position, specify "0.0" or "0.00" for this item.OFFSET Y (DUP.) and OFFSET X (DUP.) allow you to specify the printing positionof the first page of 2-sided printing. The second page of 2-sided printing followsthe settings for each paper source.IMPORTANTIf any part of the print image lies outside the printable area after adjusting theprinting position, the part will be missing in the print result.
