6-48Printing Environment Settings6SETUP Menu SettingsNOTE• To enter a numeric value for IP ADDRESS, SUBNET MASK, or GATEWAYADDRESS, press [ ] or [ ] to move the cursor to each field (an area separatedby periods to enter three-digit numbers) in which you want to enter respectivevalues of the address. The numbers in the field blinks, allowing you to enter thevalue. Pressing [ ] increases the value and [ ] decreases the value. Afterentering values in all the fields, press [OK] to confirm the setting.• For more details on the setting, see "Chapter 3 Using the Printer on a TCP/IPNetwork (Windows/UNIX)" in Network Guide.• This item is displayed only when NETWORK in the I/F CONNECTION options isset to ON.■ APPLETALKOFF*, ONSpecifies whether the printer should use AppleTalk.NOTE• For more details on AppleTalk, see "Chapter 6 Using the Printer on an AppleTalkNetwork (Macintosh)" in Network Guide.• This item is displayed only when NETWORK in the I/F CONNECTION options isset to ON.■ SMBSMB SERVER...................... OFF*, ONSMB*1 .................................. OFF*, ON*1 SMB is displayed only when an optional hard disk is installed, HARD DISK is set to ON, and SMBSERVER is set to ON.Specifies whether the printer should use the SMB protocol.NOTEThis item is displayed only when NETWORK in the I/F CONNECTION options isset to ON.■ SNMPON*, OFFSpecifies whether the printer should use the SNMP protocol.NOTEThis item is displayed only when NETWORK in the I/F CONNECTION options isset to ON.
