Turning the Printer ON and Checking the Printer Operation2-42Installing the Printer23 Select PANEL LANGUAGE using [ ] and [ ], then press[OK].4 Select the display language using [ ] and [ ], then press[OK].The display language is changed.Turning the Printer OFFTurn the printer OFF using the following procedure. The procedure for turning theprinter OFF is different between when a hard disk is used and when it is not used.IMPORTANT• When using the hard disk, be sure to turn the printer OFF as the procedure for theprotection of the hard disk. (See p. 2-43)• If the printer is connected to a network, make sure that other computers are not sendingprint data to the printer before turning the printer OFF.• If you turn the printer OFF when the (Job) indicator is on, all the print data remainingin the printer memory will be erased. If there is any necessary print data remaining in theprinter, wait until it is output, or press the (Reset) key in the offline state and thenselect FORM FEED to output the data before turning the printer OFF.• Do not turn the power OFF when the printer is in any of the following status:- During printing- While the printer is running a self-diagnostic test immediately after turning the powerON- While a message informing you that the NVRAM is being initialized or being written isdisplayed- While <02 WARMING UP> or <02 CALIBRATING> is displayed• When you are using a hard disk, make sure that the (HDD) indicator is not on. If youturn the printer OFF while the (HDD) indicator is on (while data is being read from thehard disk or being written to the hard disk), the hard disk may be damaged and disabled.PANEL LANGUAGE →=ENGLISH →FRENCH →=FRENCH →PANNEAU LANGUES→
