6-33Printing Environment Settings6SETUP Menu SettingsGUTTER-50.0 to 50.0; 0.0* (mm)Specifies the gutter width for printing with the binding location created. A gutter iscreated with the image shifted by the specified value. You can shift the image inthe "+" direction with a positive value and in the "–" direction with a negative value.Specify on which edge of the paper, the long edge or short edge, the gutter is tobe created in BIND.LOCATION (See the previous item). On which edge (top/bottom/left/right) of the paper the gutter is created depends on the setting forBIND.LOCATION and which value "+" or "-" is specified for this item.IMPORTANTIf any part of the print image lies outside the printable area after creating a gutter,the part will be missing in the print result.NOTE• Each time you press [ ], the value increases in 0.5 mm increments, and eachtime you press [ ], the value decreases in 0.5 mm increments. If you keepholding down [ ] or [ ], the speed of the value changing is increased.• If the settings for OFFSET Y and OFFSET X are specified at the same time as thesetting for this item is specified, the settings for OFFSET Y and OFFSET X areprocessed first, and then the setting for this item is processed.+ direction - direction[0 mm]GutterCenter Center CenterGutter
