Connecting the Cables2-30Installing the Printer2NOTE• This printer recognizes the type of Ethernet (100BASE-TX or 10BASE-T) automatically.• If both 100BASE-TX devices and 10BASE-T devices are on the same network, a devicesuch as a switching hub that supports both 100BASE-TX and 10BASE-T is required. Formore details, contact your local authorized Canon dealer.• If you connected this printer to a network, check the MAC address of the print server withConfiguration Page Print, and then configure the network operating system (UNIX, etc.)and print server. For more details, see "Network Guide".1 Attach the ferrite core to the LAN cable as shown in the figure.Attach the ferrite core at 5 cm or less from the end of the connector (A)connected to the printer.NOTEA ferrite core is supplied with the printer.5 cm or less(A)
