|
4-32Loading and Outputting PaperPrinting from the Paper Cassette4IMPORTANT• Match the paper size specified in the SETUP menu of the printer and that specified in theprinter driver. If they do not match, the message appears. In thiscase, the setting for CASSETTE(n) SIZE (n = 1, 2) is changed to that in the printer driverby pressing the (Online) key, allowing you to continue printing.• When custom size paper is loaded, specify the setting for CASSETTE(n) SIZE (n = 1, 2)in the control panel as follows.- When the paper is loaded in landscape orientation (Only when UFR II Printer Driver isused): CUSTOM SIZE- When the paper is loaded in portrait orientation: CUSTOM SIZE R• When you change the paper loaded in the paper cassette frequently, it is convenient ifyou set CASSETTE(n) SIZE (n = 1, 2) to MIXED SIZES. When CASSETTE(n) SIZE (n =1, 2) is set to MIXED SIZES, you do not need to change the setting for CASSETTE(n)SIZE (n = 1, 2) each time you load different size paper. However, when specifying MIXEDSIZES, make sure that the size of the loaded paper matches the paper size specified inthe printer driver before printing. If they do not match, the printer may stop printing,displaying the message <41 CHK PAPER SZE>, or a paper jam may occur. Be sure tocheck if the paper size specified in the printer driver matches the size of the paper loadedin the paper cassette before using the printer. However, if SPECIAL MODE J (See p.6-52) is set to ON, the printer prints without checking the paper size even when the papersize specified in the printer driver and the size of the paper loaded in the cassette do notmatch.• When printing custom size paper from UFR II Printer Driver, you can load the papereither in portrait or landscape orientation. However, if you want to print custom size paperof its long edges 215.9 mm or less when CASSETTE(n) SIZE (n = 1, 2) is set to MIXEDSIZES, load the paper in landscape orientation. When you are not printing from UFR IIPrinter Driver, load the paper in portrait orientation.NOTEThe names of the following paper sizes are indicated by an abbreviation.Legal: LGL, Letter: LTR, Executive: EXEC, Foolscap: FLSC1 Press the (Settings) key.2 Select FEEDER MENU using [ ] and [ ], then press [OK].SETUPCONTROL MENU →FEEDER MENU →TRAY PAPER SIZE→
|
