Windows PrintingXerox Phaser 3635 System Administration Guide 43Configure AppleTalk1. At your workstation, open the Web browser and enter the TCP/IP address of themachine in the Address bar.2. Press [Enter].3. Click on the [Properties] tab.4. Click on the [Connectivity] link.5. Click on the [Protocols] link.6. Select [AppleTalk] in the directory tree.7. Click the [Enabled] checkbox to enable the Protocol.8. Type a name for the machine in [Printer Name].9. Select the required [Zone].10. Click [Apply] to accept the changes.If prompted, enter the Administrator’s User ID [admin] and Password [1111], andclick on [Login].11. The settings are not applied until you reboot the machine. Click the [Status] tab.12. Click the [Reboot Machine] button and click [OK] to reboot the machine. Thenetwork controller takes approximately 5 minutes to reboot and network connectivitywill be unavailable during this time.Install the Printer Driver1. Follow the steps below that are specific to your operating system:Windows XPa) Click on [Start].b) Click on [Network Connections].Windows 2000/2003From the Desktop:a) Right-click on the [My Network Places] icon.b) Click on [Properties].2. Right-click on the network connection you want to configure AppleTalk on, and thenclick on [Properties].3. The [Connection Properties] dialog box opens.4. On the [General] tab, if the AppleTalk Protocol is in the list of installed protocols,make sure that it is selected. If the AppleTalk protocol is not listed, install it using thedocumentation provided by Microsoft, then return to this page.5. Follow the steps below that are specific to your operating system:Windows XPa) Click on [Start].b) Click on [Network Connections]
