9 Server Fax90 Xerox Phaser 3635 System Administration Guide2. TCP/IP and HTTP protocols must be configured on the machine so that the machineweb browser can be accessed.3. Install and configure the Xerox Partner Enterprise Fax solution on your network. Referto the manufacturer's documentation contained with the fax solution for instructionsto complete this task.4. If the Enterprise Fax solution uses the TCP/IP protocol to communicate, it isrecommended that the server is assigned a static IP Address. However, dynamic IPAddressing may be used provided DNS settings are fully configured and the DHCPserver has been configured with sufficient lease time so that the normalmaintenance and service down times of the Fax Server does not result in a change inIP Address.Insert the Feature Enablement Key1. Insert the Feature Enablement Key in the slot at the rear of the machine.2. Follow the instructions included with the Feature Enablement Key to enable theServer Fax option.3. Remove the Feature Enablement Key when instructed to do so and store it in a safelocation.Enable the Server Fax from the Machine1. Press the button on the machine to enter the Tools Pathway.2. Enter the Administrator’s Password. The default is 1111.3. Touch [Enter].4. Press the button.5. Touch [Tools].6. Touch [User Interface].7. Touch [Service Enablements].8. Touch [Server Fax].9. Touch [Enable].10. Press the button.11. Touch [Confirm] to exit the Tools Pathway.Configure a Server Fax RepositoryWhen a User faxes a document from the machine the document is stored in a directory,known as the Fax Repository. The Fax Server monitors the Fax Repository for documents tobe faxed.The machine can use 4 different ways to transfer a scanned fax to the repository:
