2 Machine Connection10 Xerox Phaser 3635 System Administration GuideSetup HTTPThe Internet Services HTTP screen enables the System Administrator to specify the KeepAlive Timeout, Maximum Connections, Port Number and Secure HTTP (SSL) settings.1. At your Workstation, open the web browser and enter the TCP/IP Address of themachine in the Address bar.2. Press [Enter].3. Click on the [Properties] tab.4. Click on the [Connectivity] link.5. Click on the [Protocols] link.6. Click on the [HTTP] link.7. The [Keep Alive Timeout] setting determines how long the machine's InternetServices pages will wait for a response from a connected user before terminating theconnection. Enter the required number of seconds (1 - 60) in the [Keep AliveTimeout] entry box.NOTE: Generally, longer amounts of time that a user is connected will tend to slowdown and tie up connections. Keep Alive Timeout controls the number of secondsthat connections remain open from the HTTP server side without any requests fromthe client reaching the server.8. The [Maximum Connections] setting is the maximum number of simultaneousconnections that can occur at any given moment to Internet Services. Enter anumber from 8 - 32 to indicate the maximum number of clients that can beconnected (for example, with open sockets) to the HTTP server in the [MaximumConnections] entry box.9. Change the HTTP [Port Number] if required. The default is 80.10. Select the [Require SSL] option as the HTTP Security Mode.NOTE: The machine must have a Machine Digital Certificate configured to enableSecure HTTP - see Machine Digital Certificate Management & Trusted CertificateAuthorities in the Security chapter on page 148.11. Click on the [Apply] button to accept the changes.12. Click on the [OK] button when the confirmation message box appears.Change the Administrator PasswordIt is recommended that you change the default administrator password to a more securepassword, so this Xerox device is not compromised.To change the admin password:1. At your Workstation, open your web browser and enter the TCP/IP Address of themachine in the Address bar.2. Press [Enter].3. Click on the [Properties] tab.4. Click on the [Maintenance] link.
