3 Network Installation16 Xerox Phaser 3635 System Administration GuideProcedureInstallation via DHCP (Dynamic Host Configuration Protocol)DHCP is enabled on the machine by default. If the machine is connected to the network, theTCP/IP information will be configured when the machine is powered on and no furtherconfiguration is required.1. Print a Configuration Report to verify that the information was assigned correctly.Installation via BOOTP or DHCPEnsure your machine is connected to the network with Ethernet cabling.1. Press the button on the machine to enter the Tools Pathway.2. Enter the Administrator’s Password. The default is 1111.3. Touch [Enter].4. Press the button.5. Touch the [Tools] tab.6. Touch [Connectivity and Network Setup].7. Touch [Advanced].8. Touch [Network Setting].9. Touch [Network Setup].10. Touch [TCP/IP Options].11. Touch [TCP/IP Settings].12. Touch [Dynamic Addressing]. By default, DHCP is selected.13. Select the required Dynamic Addressing method:• [BOOTP].• [DHCP].14. Touch [Save].15. Touch [Close].16. Touch [TCP/IP - Line Printer].17. Touch [Enable].18. If you wish to change the LPR port for your printer, touch [Port Number] and enterthe desired port number at the keypad.NOTE: While you can change the port number at which your machine will accept LPRprint jobs, it is recommended that you do this ONLY with extreme caution as mostLPR spoolers are set to send print jobs to the default port, 515.19. Touch [Save].20. Touch [HTTP].21. Touch [Enable].22. Touch [Save].
