Access CWISXerox Phaser 3635 System Administration Guide 1612. In the URL field, enter http:// followed by the IP Address of the machine. Forexample: If the IP Address is 192.168.100.100, enter the following into the URL field:192.168.100.100.3. Press [Enter] to view the Home page.4. Click a tab to access the desired page, or click on the Index icon at the top of themachine web page to access the index and contents list.Network Factory Default buttonThis button can be found on the [Status] tab and is used to reset Network parameters tofactory default values from the Internet. It causes the machine to set all Network valuesback to factory default. This will cause an Immediate Image Overwrite of any incompleteprint or network scan jobs being processed when the Network Controller is rebooted.Once the button is selected, the following will occur:1. If the System Administrator is already authenticated as an administrator themachine will reboot. The web-browser will not be able to connect to the machine viathe Web UI until the network controller has reset.2. If the System Administrator is not already authenticated, the AdministrationAuthentication screen will appear so authentication can be performed. Once this hassuccessfully occurred, the Administration Authentication screen will close and themachine will reboot. The web browser will not be able to connect to the machine viathe CWIS until the Network Controller has been reset.GeneralThe General page allows you to view the Name, Location, IP Address and Status of themachine.1. At your Workstation, open the web browser, enter the TCP.IP Address of the machinein the Address bar.2. Press [Enter].3. Click on the [Status] tab.4. Click on the [General] link.Rebooting the machineIt is possible to reboot the machine from CentreWare Internet Services by clicking on[Reboot Machine]. The Network Controller takes approximately 5 minutes to reboot andnetwork connectivity will be unavailable during this time.AlertsThe Alerts page allows you to view all current alert messages. Each alert will specify what theproblem is and a solution to the problem.1. At your Workstation, open the web browser, enter the TCP/IP Address of the machinein the Address bar.
