Configure Xerox Secure Access on the DeviceXerox Phaser 3635 System Administration Guide 157Access the Authentication PageTo access the [Authentication] Page:1. Open your web browser and enter the TCP/IP address of the device in the Addressbar. Press [Enter].2. Click the [Properties] tab.3. If prompted, enter the User ID and Password of the device administrator account.The default is [admin] and [1111]. Click [Login].4. Click [Security].5. Click [Authentication].Configure Xerox Secure AccessTo configure Secure Access on the device, on the [Authentication] Page:1. Select [Required Network Authentication].2. In [Authentication Type], select [Xerox Secure Access].3. In [Feature Coverage], select the desired feature coverage. The options include:• All features — authentication must be performed to access all of the deviceservices.• Scanning features only — the supported services, such as copy and fax, will notrequire authentication.4. In [Accounting Code Access], if you want the Secure Access Server to provideNetwork Accounting Codes, select [Enable].5. In [Login Initiation], if you want to allow users to enter their information via thelocal user interface, select [Enable].This feature may be helpful in situations where the user’s card is not available or whenthe card reader is not used.6. In [Default Title], enter a title that will display on the Xerox device screen.7. In [Default Prompt], specify the prompt that will show on the Xerox device screen totell the user what they need to do to be authenticated at the device.NOTE: If the Title and Prompt have been configured in the Xerox Secure AccessServer, then this information will overwrite the [Default Title] and [Default Prompt]text entered within Internet Services.8. Click [Apply].
