TCP/IPXerox Phaser 3635 System Administration Guide 1723. Touch [Close] three times.Configure IPv4 or IPv6 Settings using CentreWare Internet ServicesIPv41. At your Workstation, open the Web browser and enter the TCP/IP Address of themachine in the Address bar.2. Press [Enter].3. Click on the [Properties] tab.4. Click on the [Connectivity] link.5. Click on the [Protocols] link.6. Select [TCP/IP] from the directory tree.7. Ensure that [IPv4] is selected. The Protocol will show as [Enabled].NOTE: If you deselect the Protocol Enabled checkbox you will not be able to accessInternet Services. TCP/IP must then be enabled from the device's user interface.8. Enter a unique [Host Name] for your machine.9. Select the desired method for obtaining a dynamic IP address from the [IP AddressResolution] drop down list or select [Static] to give the machine a static IP address.10. If [Static] has been selected, type the IP addresses that apply in [Machine IPAddress], [Subnet Mask], and [Gateway Address].NOTE: If BOOTP or DHCP address resolution mode is selected, you cannot change the IPaddress, Subnet Mask, or default gateway.Domain Name11. Enter a valid [Domain Name].DNS Configuration12. Enter an IP address for the [Preferred DNS Server]. Enter an IP address for[Alternate DNS Servers 1] and [2].13. Check the box to enable [Dynamic DNS Registration].NOTE: If your DNS Server does not support dynamic updates there is no need to enableDDNS.Zero-Configuration Networking14. Select the [Self Assigned Address] enabled box to allow the machine to assign itselfan IP address of 169.254.x.x. This is useful in situations where the device cannotconnect to the DHCP server to obtain an IP address.15. Select the [Multicast DNS] enabled box if you want to enable the device to performDNS queries over IP Multicast. This is essential for the Apple Bonjour protocol to mapa host name to an IP address, used to advertise the services of the device.
