Connection PortsXerox Phaser 3635 System Administration Guide 7RearPhone Line PortThis port is used to connect the machine directly to the fax line.EXT PortThis port is used to allow a handset to be connected to the machine.USB 2.0 PortThis port is used to allow direct printing and for Diagnostic purposes by the Service Engineer.Ethernet Port - 10 Mbps/100 MbpsThe machine is compatible with SMB, LPD, AppleTalk, NetWare, IPP, HTTP, DHCP, LDAP,SNMP, DDNS and Port9100. It supports an Ethernet connector as a standard feature.There are five Ethernet interface options available on the touch screen: Auto, 100 Mbps Full-Duplex, 100 Mbps Half-Duplex, 10 Mbps Full-Duplex, and 10 Mbps Half-Duplex. When[Auto] is selected, the machine detects the communication speed automatically whenpowered on and adjusts its settings accordingly.AppleTalk, NetWare and TCP/IP protocols that use Ethernet can be switched automaticallyaccording to the applied transmission protocol.Card Reader for Feature Enablement KeyThe Feature Enablement Key allows certain features or services, such as fax, to be fullyinstalled.Foreign Device Interface (FDI) PortThis port allows a third party FDI device to be attached to the machine. FDIs are access andaccounting devices, such as counters, card readers or coin-operated devices.Initial ConnectionFollow these steps to physically connect your machine to the network:1. Connect the Power CableEnsure that the machine is connected to a suitable power supply and that the powercord is fully plugged into the electrical outlet.2. Connect the Ethernet CableConnect a 10/100 BaseT Ethernet cable to the Ethernet port at the rear of themachine and the other end of the cable to your network port.3. Power on the machineThe Power On button is located at the rear of the machine.4. Complete the Steps shown by the Installation WizardIf this is the first time the machine has been powered on, the Installation Wizard willrun.
