3 Network Installation30 Xerox Phaser 3635 System Administration Guide7. Click on [Remote Unix (lpd) Queue].8. Click on [OK].9. The [Edit Remote Unix (lpd) Queue Entry] window will appear.10. Enter the name of your Print Queue in the [Names] area.11. The Spool directory is the directory where print jobs are stored and is a subdirectoryof [/var/spool/lpd]. Add the name of the print queue to the end of the subdirectorypath.12. Ensure that the [File Limit] reads 0.13. In the [Remote Host] area, enter the IP Address of the Xerox machine.14. In the [Remote Queue] area, enter the Print Queue Name from step 10.15. DO NOT click on the [Input Filter] option.16. Leave the default [Suppress Headers] selected.17. Click on [OK].18. The printer should now be listed in the Red Hat Linux Print System Managerwindow. Click on the [lpd] menu.19. Click on [Restart lpd].20. Click on the [PrintTool] menu.21. Click on [Exit] to close the program.22. To allow access to the printer, edit the [/etc/hosts] table to list the client system.23. Edit and create the [/etc/hosts.lpd] file to list the client system.Dynamic AddressingInformation ChecklistSee Chapter 3, Configure Dynamic IPv4 Addressing using the Machine User Interface,Information Checklist on page 15.Procedure1. Follow the steps in Chapter 3, Configure Dynamic IPv4 Addressing using the MachineUser Interface, Procedure on page 16 until step 38, then return to this page.IMPORTANT: Click on [BOOTP] in step 9.Create the Print Queue2. Follow the steps above in Create the Print Queue on page 29.
