Model 2461 Interactive SourceMeter® Instrument Reference Manual Section 8: TSP command reference2461-901-01 A/November 2015 8-239The event parameter may be any of the trigger events shown in the following table.Trigger eventsEvent description Event constantNo trigger event trigger.EVENT_NONEFront-panel TRIGGER key press trigger.EVENT_DISPLAYNotify trigger block N (1 to 8) generates a trigger event whenthe trigger model executes ittrigger.EVENT_NOTIFYNA command interface trigger:• Any remote interface: *TRG• GPIB only: GET bus command• VXI-11: VXI-11 command device_triggertrigger.EVENT_COMMANDLine edge (either rising, falling, or either based on theconfiguration of the line) detected on digital input line N(1 to 6)trigger.EVENT_DIGIONLine edge detected on TSP-Link synchronization line N(1 to 3)trigger.EVENT_TSPLINKNAppropriate LXI trigger packet is received on LAN triggerobject N (1 to 8)trigger.EVENT_LANNTrigger event blender N (1 to 2), which combines triggereventstrigger.EVENT_BLENDERNTrigger timer N (1 to 4) expired trigger.EVENT_TIMERNSource limit condition occurs trigger.EVENT_SOURCE_LIMITExampledigio.line[3].mode = digio.MODE_TRIGGER_INdigio.line[5].mode = digio.MODE_TRIGGER_INtrigger.digin[3].edge = trigger.EDGE_FALLINGtrigger.digin[5].edge = trigger.EDGE_FALLINGtrigger.blender[1].orenable = truetrigger.blender[1].stimulus[1] = trigger.EVENT_DIGIO3trigger.blender[1].stimulus[2] = trigger.EVENT_DIGIO5Generate a trigger blender 1event when a digital I/Otrigger happens on line 3 or5.Also seetrigger.blender[N].reset() (on page 8-238)trigger.blender[N].wait()This function waits for a blender trigger event to occur.Type TSP-Link accessible Affected by Where saved Default valueFunction YesUsagetriggered = trigger.blender[N].wait(timeout)triggered Trigger detection indication for blenderN The trigger blender (1 or 2) on which to waittimeout Maximum amount of time in seconds to wait for the trigger blender event
