Section 6: SCPI command reference Model 2461 Interactive SourceMeter® Instrument Reference Manual6-42 2461-901-01 A/November 2015:DISPlay:READing:FORMatThis command determines the format that is used to display measurement readings on the front-panel display ofthe instrument.Type Affected by Where saved Default valueCommand and query Not applicable Nonvolatile memory PREFUsage:DISPlay:READing:FORMat :DISPlay:READing:FORMat? Use exponent format: EXPonentAdd a prefix to the units symbol, such as k, m, or μ: PREFixDetailsThis setting persists through *RST and power cycles.When Prefix is selected, prefixes are added to the units symbol, such as k (kilo) or m (milli). WhenExponent is selected, exponents are used instead of prefixes. When the prefix option is selected, verylarge or very small numbers may be displayed with exponents.ExampleDISP:READ:FORM EXP Change front-panel display to show readings inexponential format.Also seeSetting the display format (on page 2-46):DISPlay:SCReenThis command changes which front-panel screen is displayed.Type Affected by Where saved Default valueCommand only Not applicable Not applicable Not applicableUsage:DISPlay:SCReen The screen to display:• Home screen: HOME• Home screen with large readings: HOME_LARGe_reading• Reading table: READing_table• Graph screen (opens last selected tab): GRAPh• Histogram screen: HISTogram• GRAPH swipe screen: SWIPE_GRAPh• SETTINGS swipe screen: SWIPE_SETTings• SOURCE swipe screen: SOURce• STATISTICS swipe screen: SWIPE_STATistics• USER swipe screen: SWIPE_USER
