Section 6: SCPI command reference Model 2461 Interactive SourceMeter® Instrument Reference Manual6-86 2461-901-01 A/November 2015:SOURce[1]:CONFiguration:LIST:RECallThis command recalls a specific configuration index in a specific source configuration list and an optional measureconfiguration list.Type Affected by Where saved Default valueCommand only Not applicable Not applicable Not applicableUsage:SOURce[1]:CONFiguration:LIST:RECall "", :SOURce[1]:CONFiguration:LIST:RECall "", , "":SOURce[1]:CONFiguration:LIST:RECall "", , "", A string that represents the name of a source configuration list A number that defines a specific configuration index in the source configuration list A string that represents the name of a measure configuration list<measureIndex> A number that defines a specific configuration index in the measure configuration listDetailsUse this command to recall the settings stored in a specific configuration index in a specific sourceconfiguration list. If you do not specify an index when you send the command, it recalls the settingsstored in the first configuration index in the specified source configuration list of that index.You can optionally specify a measure configuration list and index to recall with the source settings. Ifyou do not specify a measure index, the measure index defaults to match the source index. Specify asource and measure list together with this command to allow the instrument to coordinate theapplication of the settings in the two lists appropriately. If you do not need have the application of thesource and measure configuration lists coordinated, you can specify just the source configuration listwith this command and use the [:SENSe[1]]:CONFiguration:LIST:RECall (on page 6-76) command torecall measure settings separately in your application.If you recall an invalid index (for example, calling index 3 when there are only two indexes in theconfiguration list) or try to recall an index from an empty configuration list, event code 2790,"Configuration list, error, does not exist" is displayed.Each index contains the settings for the selected function of that index. Settings for other functionsare not affected when the configuration list index is recalled. To see what settings are going to berecalled with an index, use the :SOURce[1]:CONFiguration:LIST:QUERy? (on page 6-85) command.Note: If you are going to recall a source configuration list separately (not with this command), recallthe source configuration list before the measure configuration list. This order ensures thatdependencies between source and measure settings will be properly handled.
