Section 6: SCPI command reference Model 2461 Interactive SourceMeter® Instrument Reference Manual6-144 2461-901-01 A/November 2015:SYSTem:CCHeck:THResholdThis command sets the threshold value for contact resistance for the contact check status functions.Type Affected by Where saved Default valueCommand and query Instrument resetPower cycleNot saved OHM50Usage:SYSTem:CCHeck:THReshold :SYSTem:CCHeck:THReshold? The level of threshold resistance above which the contact check functions indicate afailure:• 2 Ω: OHM2• 15 Ω: OHM15• 50 Ω: OHM50DetailsThe contact check functions indicate a failure when the connection path resistance exceeds the valuespecified by this command.This command can be sent when contact check isn't enabled. However, you must enable contactcheck before checking the status of connections.Example:SYSTem:CCHeck:THReshold OHM15:SYSTem:CCHeck:THReshold?Set the contact check function to indicate afailure if resistance is greater than 15 Ω.Query the contact check threshold setting.Output:OHM15Indicates that the contact check threshold is setto 15 Ω.Also see:SYSTem:CCHeck? (on page 6-142):SYStem:CCHeck:ALL? (on page 6-142):SYSTem:CCHeck:STATe (on page 6-143)
