Appendix D: Convert Model 2400 to Model 2461 code Model 2461 Interactive SourceMeter® Instrument Reference ManualD-6 2461-901-01 A/November 2015Pulsing (Model 2430 feature)If you are bringing code from a Model 2430 to a Model 2461, the pulsing features and commandshave changed significantly. Refer to Pulse operation (on page 3-64) for a general discussion. Forspecific commands, refer to the following command descriptions:• :SOURce[1]:PULSe::LIMit[:LEVel] (on page 6-104)• :SOURce[1]:PULSe:[:LEVel][:IMMediate][:AMPLitude] (on page 6-105)• :SOURce[1]:PULSe:LIST: (on page 6-107)• :SOURce[1]:PULSe:LIST::APPend (on page 6-108)• :SOURce[1]:PULSe:LIST::POINts? (on page 6-109)• :SOURce[1]:PULSe:SWEep::LINear (on page 6-110)• :SOURce[1]:PULSe:SWEep::LINear:STEP (on page 6-113)• :SOURce[1]:PULSe:SWEep::LIST (on page 6-116)• :SOURce[1]:PULSe:SWEep::LOG (on page 6-118)• :SOURce[1]:PULSe:TRain: (on page 6-121)Model 2400 to Model 2461 SCPI command cross-referenceThis section provides information to help you convert existing Model 2400 SCPI code to Model 2461SCPI code.You must use the command set SCPI to use the new commands. See Determining the command setyou will use (on page 2-80) for information on setting the command set.This section lists the SCPI commands that were available with the Model 2400, cross-referenced tothe equivalent commands in the Model 2461 where available. Differences between the commandsare noted. If no differences are noted, the command should operate the same on the Model 2461 as itdid in the Model 2400.CALCulate[1] subsystemModel 2400 command :CALCulate[1]:DATA?Model 2461 command Not supportedNotes Use buffer to get user math data; see the TRACe subsystem (on page 6-156).Model 2400 command :CALCulate[1]:DATA:LATest?Model 2461 command Not supportedNotes Use buffer to get user math data; see the TRACe subsystem (on page 6-156).Model 2400 command :CALCulate[1]:MATH[:EXPression]:CATalog?Model 2461 command Not availableNotes
