Section 6: SCPI command reference Model 2461 Interactive SourceMeter® Instrument Reference Manual6-222 2461-901-01 A/November 2015:TRIGger:LOAD "ConfigList"This command loads a predefined trigger model configuration that uses source and measure configuration lists.Type Affected by Where saved Default valueCommand only Not applicable Not applicable Not applicableUsage:TRIGger:LOAD "ConfigList", "", "":TRIGger:LOAD "ConfigList", "", "", :TRIGger:LOAD "ConfigList", "", "", ,"":TRIGger:LOAD "ConfigList", "", "", ,"", A string that contains the name of the measurement configuration list touse A string that contains the name of the source configuration list to use The delay time before each measurement (167 ns to 10 ks); default is 0 forno delay A string that indicates the reading buffer; the default buffers (defbuffer1or defbuffer2) or the name of a user-defined buffer; if no buffer isspecified, defbuffer1 is used Define a measure or digitize block for the trigger model; options are:• ACTive: Add a measure or digitize block to the trigger model basedon the active function; if no option defined, ACTive is used• MEASure: Adds a measure block to the trigger model• DIGitize: Adds a digitize block to the trigger modelDetailsThis trigger model template incorporates a source configuration list and measure configuration list.You must set up the configuration lists before loading the trigger model.You can also set a delay and change the reading buffer.After selecting a trigger model template, you can view the trigger model blocks in a graphical formatby pressing the front-panel MENU key and under Trigger, selecting Configure. You can also add ordelete blocks and change trigger model settings from this screen. You can use theTRIGger:BLOCk:LIST? command to view the trigger model blocks in a list format.This command replaces the TRIGger:LOAD:CONFiguration:LIST command, which isdeprecated.
