Model 2461 Interactive SourceMeter® Instrument Reference Manual Section 6: SCPI command reference2461-901-01 A/November 2015 6-91:SOURce[1]::DELay:USERThis command sets a user-defined delay that you can use in the trigger model.Type Affected by Where saved Default valueCommand and query Recall settingsInstrument resetPower cycleSource configuration listSave settingsSource configuration list0Usage:SOURce[1]::DELay:USER :SOURce[1]::DELay:USER?:SOURce[1]::DELay:USER? DEFault:SOURce[1]::DELay:USER? MINimum:SOURce[1]::DELay:USER? MAXimum The source function to which this setting applies:• Current: CURRent• Voltage: VOLTage The number that identifies this user delay (1 to 5) The time of the delay in seconds (0 to 10,000)DetailsTo use this command in a trigger model, assign the delay to the dynamic delay block.The delay is specific to the selected function.Example:SOUR:VOLT:DEL:USER1 5:TRIG:BLOC:SOUR:STAT 1, ON:TRIG:BLOC:DEL:DYN 2, SOUR1:TRIG:BLOC:MEAS 3:TRIG:BLOC:SOUR:STAT 4, OFF:TRIG:BLOC:BRAN:COUN 5, 10, 1:INITSet user delay for source 1 to 5 s.Set trigger block 1 to turn the source output on.Set trigger block 2 to a dynamic delay that callssource user delay 1.Set trigger block 3 to make a measurement.Set trigger block 4 to turn the source output off.Set trigger block 5 to branch to block 1 ten times.Start the trigger model.Also see:TRIGger:BLOCk:DELay:DYNamic (on page 6-200)
