Section 4: Source-measure considerations Model 2461 Interactive SourceMeter® Instrument Reference Manual4-26 2461-901-01 A/November 2015Default valuesMath and limit reset valuesSetting Default value onresetMENU > Measure > Calculations > Filter > Config > FilterCount[:SENSe[1]]::AVERage:COUNt (on page 6-53)smu.measure.filter.count (on page 8-148)10MENU > Measure > Calculations > Filter[:SENSe[1]]::AVERage[:STATe] (on page 6-55)smu.measure.filter.enable (on page 8-148)OffMENU > Measure > Calculations > Filter > Config > FilterType[:SENSe[1]]::AVERage:TCONtrol (on page 6-56)smu.measure.filter.type (on page 8-149)RepeatMENU > Measure > Calculations > Math > Config:CALCulate[1]::MATH:FORMat (on page 6-19)smu.measure.math.format (on page 8-159)PercentMENU > Measure > Calculations > Math > Config > MathFormat > mx+b > b (Offset):CALCulate[1]::MATH:MBFactor (on page 6-20)smu.measure.math.mxb.bfactor (on page 8-160)0MENU > Measure > Calculations > Math > Config > MathFormat > mx+b >m (Scalar):CALCulate[1]::MATH:MMFactor (on page 6-22)smu.measure.math.mxb.mfactor (on page 8-162)1MENU > Measure > Calculations > Math > Config > MathFormat > Zero Reference:CALCulate[1]::MATH:PERCent (on page 6-23)smu.measure.math.percent (on page 8-163)1.0MENU > Measure > Calculations > Math:CALCulate[1]::MATH:STATe (on page 6-24)smu.measure.math.enable (on page 8-158)OffMENU > Measure > Calculations > Limit1 > Auto Clear:CALCulate2::LIMit:CLEar:AUTO (on page 6-26)smu.measure.limit[Y].autoclear (on page 8-153)OnMENU > Measure > Calculations > Limit1 > Low Value:CALCulate2::LIMit:LOWer[:DATA] (on page6-30)smu.measure.limit[Y].low.value (on page 8-158)–1MENU > Measure > Calculations > Limit1 > High Value:CALCulate2::LIMit:UPPer[:DATA] (on page6-33)smu.measure.limit[Y].high.value (on page 8-157)1MENU > Measure > Calculations > Limit1 > Audible:CALCulate2::LIMit:AUDible (on page 6-25)smu.measure.limit[Y].audible (on page 8-152)None
