101[Setting]Setting Don't disconnect the console from the driver between to . Should the connector is pulled out, insert it again and repeat the procedures from the beginning. If the error display repeats frequently, check the broken cable, disconnection of the connector,misoperation due to noise or failure of console.Initialization of EEPROM of the console starts.Copying completes normally.Error displayTo move to the next process, press .The positioning parameter is copiedfrom the servo driver into theconsole and the positioningparameter is written into EEPROM(console).The servo parameter and drivertype code are copied from the servodriver into the console and thedriver type code of the servoparameter is written into EEPROM(console). If error is displayed, repeat the procedures from the beginning. Press for releasing error.Starting from initial LED status, Press six time after pressing , then press , to make a display toPress to call for EXECUTION DISPLAY ofKeep pressing until the console display (LED) changes to .“ ” increases by pressing (approx. 3sec) as the left fig. shows.SELECTION displayWhen you have finished the copy, press to return to .Copying Function (Console Only)Copying of Parameters from the Driver to the ConsoleOperation at SELECTION displayOperation at EXECUTION display
