1233-11 On-the-fly Marking Commands3-11-1 Motion settings: TRGSupported model: LP-RC series / LP-RF series / LP-RV seriesSets the basic configuration of the on-the-fly marking, such as moving direction and etc. The settings are applied to allmarking files.⿎ Setting request data / response data for readoutStartcode TRG Subcommand[Moving direction] [Line speed control][Trigger mode]3-byte(Checksum) End codeSub command is “S” for the setting request data and “A” for the response data for readout.⿎ Readout request dataStartcode TRG R (Check sum) End code⿎ Data descriptionName Data length[byte] Data contents RemarksMoving direction 1“0”: Marking to static object“1”: +X to -X (Left)“2”: -X to +X (Right)“3”: +Y to -Y (Front)“4”: -Y to +Y (Back)• Specify “0” to disable on-the-flymarking.• The direction of X/Y axis is defined bythe head direction setting in Systemsettings.Line speed control 1 “0”: Fixed speed“1”: Encoder inputWith LP-400/V compatible commandmode, “2 sensors input” cannot be set andreadout.Trigger mode 1 “0”: Single trigger“1”: Marking at regular intervals• “Single trigger” corresponds to “triggermarking” of LP-400/LP-V series.• With LP-400/V compatible commandmode, “multiple triggers” cannot be setand readout.Total data length 3 Fixed length.ンㄆㄇㄆㄓㄆㄏㄆ• Any of the following functions that are not available with on-the-fly marking are configured.• Link control with external image checkers• Overwriting interval• Skip marking of 2D code (Setting of module marking order)• When the trigger mode is set to Marking at regular intervals, those functions are also not available.• Registered characters (via I/O)• External Offset including SEO command• Characters specified by SIN command• Counter reset at date change• The setting changed by this command is saved in the laser marker without overwriting to the file.• The “Delay distance” which was specified in LP-400/V series is corresponding to “Trigger detecting position” and“Workpiece reference boundary” in this product. If you want to set those parameters, switch the command mode to thestandard mode by RMS command.ME-LP-GS-SR-COMP-3
