1293-12-3 Laser frequency / pulse cycle: MPLSets the laser frequency (LP-GS/LP-RC) or pulse cycle (LP-RF/LP-RV) for the current file.ンㄆㄇㄆㄓㄆㄏㄆ• The settings by this command are applied to all objects in the file. With LP-RF/LP-RV series, if you want to change thepulse cycle correction value of the specified object only, set the pulse cycle correction by each object setting.• With LP-400/V compatible command mode, the available setting range of the pulse cycle for LP-RV series is limited. Ifthe setting value exceeds the limit, it is not possible to readout the settings by this command.• For LP-RV series, the pulse duration is set to 30ns when you set the pulse cycle by this command.⿎ Setting request data / response data for readoutStartcode MPL Subcommand[Laser frequency/Pulse cycle]LP-GS/LP-RC: 1-byteLP-RF/LP-RV: 4-byte(Checksum) End codeSub command is “S” for the setting request data and “A” for the response data for readout.⿎ Readout request dataStartcode MPL R (Check sum) End code⿎ Data descriptionName Data length[byte] Data contents RemarksLaser frequencyorPulse cycle1or4Model Setting rangeLP-GS051(-L)LP-GS052“0”: 5 kHz“1”: 10 kHz“2”: 20 kHzLP-RC350S “3”: 40 kHzLP-RF200P “05.0”–“50.0” [μs]LP-RV200P “01.2”–“99.9” [μs]• For LP-GS/LP-RC series, set thelaser frequency (1-byte).• For LP-RF/LP-RV series, set thepulse cycle (4-byte).• For LP-RV series, the pulse durationis set to 30ns when you set thepulse cycle by this command.Total data length1or4Fixed length.• LP-GS/LP-RC series: 1-byte• LP-RF/LP-RV series: 4-byte⿎ Example of command settingsCondition: LP-GS series, Laser frequency=20• Setting Transmission data [STX] MPL S 2 [CR]• Readout Transmission data [STX] MPL R [CR]Response data [STX] MPL A 2 [CR]Condition: LP-RF series, Pulse cycle = 40• Setting Transmission data [STX] MPL S 40.0 [CR]• Readout Transmission data [STX] MPL R [CR]Response data [STX] MPL A 40.0 [CR]ME-LP-GS-SR-COMP-3
