1033-7-5 Module filling of 2D codes: BRPSets the laser settings and filling details with a font by each element of the 2D code (QR codes and Data matrix codes).ンㄆㄇㄆㄓㄆㄏㄆ• If the object type set in the specified object number is not the bar code/2D code, the laser marker returns the negativeresponse.• The settings by this command are applied only to QR codes, micro QR codes, Data matrix codes and GS1 Data matrixcodes. To specify the module fill spacing of the other codes, use WDC command (line width / filling line spacing).• With LP-400/V compatible command mode, you cannot set and readout the settings for QR code for Chinese characters(GB/T 18284) and iQR code by this command.• With LP-400/V compatible command mode, you cannot set and readout the settings for QR code with the mode setting“Auto” by this command.• With LP-400/V compatible command mode, the other filling patterns than the font cannot be set and readout.⿎ Setting request data / response data for readoutStartcode BRP Subcommand[Object No.] [Code element] [Character code][Laser power correction] [Scan speed correction][Pulse cycle correction]LP-GS/LP-RC: 12-byteLP-RF/LP-RV: 15-byte(Checksum) End codeSub command is “S” for the setting request data and “A” for the response data for readout.⿎ Readout request dataStartcode BRP R [Object No.] [Code element]2-byte(Checksum) End code⿎ Data descriptionName(> Name in LP-400/V)Data length[byte] Data contents RemarksObject No.(> Bar code No.) 1 “0”–“7”: Object No. 1100 to 1107Code element 1QR code:“0”: Quiet zone outline“1”: Dark module“2”: Light module“3”: Alignment“4”: Finder When the code type is micro QR code, youdo not need to set “alignment”.Data Matrix code:“0”: Quiet zone outline“1”: Dark module“2”: Light module“3”: BorderCharacter code(JIS Code) 4“2230”–“2239”“8121”–“8152”“0000”: Do not mark, or use thesame setting with the dark/lightmodule for the alignment, finder orborder.• Specifies the character code of the fontused as a filling pattern in JIS code.• To the quiet zone outline, dark moduleor light module, inputting the charactercode “0000” encodes the 2D code withblank for the specified part.• To the alignment, finder or border,inputting the character code “0000”allows to use the same filling pattern ofthe dark/light module.ME-LP-GS-SR-COMP-3
