603-3-5 Trigger delay: DLYSets the delay time from trigger input to starting trigger processing (lasing) operation. Trigger delay setting is applied to onlythe selected file.⿎ Setting request data / response data for readoutStartcode DLY Subcommand[Delay time]6-byte (Check sum) End codeSub command is “S” for the setting request data and “A” for the response data for readout.⿎ Readout request dataStartcode DLY R (Check sum) End code⿎ Data descriptionName Data length [byte] Data contents RemarksDelay time 6 “000000”–“009999” [ms]Total data length 6 The data length is fixed.ンㄆㄇㄆㄓㄆㄏㄆ• Trigger delay setting is applied to only the selected file. When you use several files, set the trigger delay for each file.• When in the selected file the link control with an image checker is set, the link control starts after the trigger delay time.There is no delay time before TIMING IN.• The delay time setting is applied only to the marking to static object. When the on-the-fly marking is set, you cannot useDLY command.• The “Delay distance” which was specified in LP-400/V series is corresponding to “Trigger detecting position” and“Workpiece reference boundary” in this product. If you want to set those parameters, switch the command mode to thestandard mode by RMS command.⿎ Example of command settingsCondition: Delay time = 75• Setting Transmission data [STX] DLY S 000075 [CR]• Readout Transmission data [STX] DLY R [CR]Response data [STX] DLY A 000075 [CR]ME-LP-GS-SR-COMP-3
