563-3 Operation Control Commands3-3-1 Command reception permission: MKMControls the reception permission (reception mode ON/OFF) of the settings by communication commands.In the shutter open or marking trigger ready ON status, set “command reception permission ON” when transmitting thecommand including an action to update the laser marker data.To resume the marking trigger ready ON status after command transmission, set “command reception permission OFF”.⿎ Setting request data / response data for readoutStartcode MKM Sub command [Command reception permission]1-byte (Check sum) End codeSub command is “S” for the setting request data and “A” for the response data for readout.⿎ Readout request dataStartcode MKM R (Check sum) End code⿎ Data descriptionName Data length[byte] Data contents RemarksCommandreceptionpermission1“0”: Command receptionpermission ON“1”: Command receptionpermission OFFSetting “command reception permission ON” turnsOFF the marking trigger ready to start receivingcommands.Setting “command reception permission OFF” endsthe command reception to resume the marking triggerready ON status.Total datalength 1 The data length is fixed.ンㄆㄇㄆㄓㄆㄏㄆ• Refer to “2-4 Command Reception Condition” (P.42) for details on the command reception permission.• Send MKM command with the shutter opened state.• When the command reception status is readout during the shutter closed, the response data indicates the status as“command reception permission ON”.• MKM command is not acceptable during the guide laser emission or laser radiation for measurement.• It is possible to recover from the warning status by sending “command reception permission ON” of the MKM command.⿎ Example of command settingsCondition: Command reception permission = 0• Setting Transmission data [STX] MKM S 0 [CR]• Readout Transmission data [STX] MKM R [CR]Response data [STX] MKM A 0 [CR]ME-LP-GS-SR-COMP-3
