1153-10-3 External offset values: OFSSets offset value of marking position used for “External Offset Function” with I/O input.⿎ Setting request data / response data for readoutStartcode OFS Subcommand[Data number] [X-movement] [Y-movement][Rotation movement]26-byte(Checksum) End codeSub command is “S” for the setting request data and “A” for the response data for readout.⿎ Readout request dataStartcode OFS R [Data number]3-byte (Check sum) End code⿎ Data descriptionName Data length[byte] Data contents RemarksData number 3 “000”–“255” Specifies the data number for whichthe external offset is set.X-movement 8“-999.999”–“+999.999” [mm] • Moves the coordinate of the allmarking data in the file.• The rotation center is the centerof the marking field.Y-movement 8Rotationmovement 7 “-180.00”–“+180.00” [°]Total data length 26 Fixed length.ンㄆㄇㄆㄓㄆㄏㄆ• This command can be used when the input method of the external offset is I/O input setting. If “Using SEO command” isset, switch the command mode to the standard mode by RSM command and then send SEO command.• With LP-400/V compatible command mode, Z-movement and laser power correction of the external offset cannot be set.For these settings, the data set last (the initial value if it was not set) will be applied.⿎ Example of command settingsCondition: Data number = 5, X-movement = 10, Y-movement = -5.5, Rotation movement = 90• Setting Transmission data [STX] OFS S 005+010.000-005.500+090.00 [CR]• Readout Transmission data [STX] OFS R 005 [CR]Response data [STX] OFS A 005+010.000-005.500+090.00 [CR]ME-LP-GS-SR-COMP-3
