Panasonic LP-GS Series Serial Communication Command Manual

Also see for LP-RF Series: Serial Communication Command Guide Quick reference Operation manual Setup & maintenance guide

Contents

Panasonic LP-GS Series Serial Communication Command Manual Manual pdf 118 page image

1183-10-5 Step & repeat fine-adjustment: SRASets the fine-adjustment of “Step & repeat” to mark the same marking contents on multiple locations in one file.Setting request data / response data for readout vary by the setting subject to fine-adjustment.ンㄆㄇㄆㄓㄆㄏ㄄ㄆ• Settings by this command are applied to the object group No. 1000. To the object group No. 1000 the marking dataconverted from LP-400/V files and the data set by LP-400/V compatible command mode belong.• With LP-400/V compatible command mode, only 100 settings of Step & repeat fine adjustment are available.• With LP-400/V compatible command mode, Z-movement cannot be set and readout.• With LP-400/V compatible command mode, “rectangle range” of the adjustment object cannot be set and readout.⿎ Readout request dataStartcode SRA R [Adjustment No.]2-byte(Checksum) End code⿎ Setting request data / response data for readout: position/power adjustment for single stepStartcode SRA Subcommand[Adjustment No.] [Adjustment object][Target row] [Target column] [Adjustment item][X-movement] [Y-movement]( [Rotation movement] [Laser power correction] )35-byte or 25-byte(Checksum) End codeSub command is “S” for the setting request data and “A” for the response data for readout.⿎ Data descriptionName Data length[byte] Data contents RemarksAdjustment No. 2 “00”–“99”Adjustment object 1 “1”: Single stepTarget row 3“001”–“400” Enables the adjustment item for theselected row/column.Target column 3X-movement 8“-999.999”–“+999.999” [mm]• Moves the coordinate of the markingdata in the range of rows/columnsspecified.• It is the movement for the coordinateafter executing Step & repeat.• When the rotation movement is omitted,“+000.00” is set.Y-movement 8Rotation movement * (7) “-180.00”–“+180.00” [°]Laser powercorrection * (3) “-50”–“+50” [+/-%]• Corrects the laser power of the markingdata in the range of rows/columnsspecified. Specify the correction ratioin the range of 100±50% relative to thelaser power for the object to which Step& repeat applies.• When this item is omitted, “+00” is set.Total data length 35(25)Fixed length.• When Rotation movement and Laser power correction are not omitted: 35-byte• When Rotation movement and Laser power correction are omitted: 25-byte• Response data for readout: 35-byte* These items can be omitted when the both values are 0. It is not possible to omit one side of them.ME-LP-GS-SR-COMP-3