122⿎ Setting request data: Setting deletionStartcode SRA S[Adjustment No.] [Adjustment object][Number of adjustment settings to delete]6-byte or 3-byte(Checksum) End code⿎ Data descriptionName Data length[byte] Data contents RemarksAdjustment No. (Fromwhich the deletion starts) 2 “00”–“99” Specifies the number to delete or the numberfrom which the deletion starts.Adjustment object(Delete command) 1 “0”: Delete settingsNumber of adjustmentsettings to delete * (3) “001”–“100”• Specifies the number of conditions to deletebefore deleting consecutive adjustmentsettings after the specified adjustment number.• If you omit this item, only the settings of thespecified adjustment number will be deleted.(The setting to delete one row.)Total data length 6(3)Fixed length.• When Number of adjustment settings to delete is not omitted: 6-byte• When Number of adjustment settings to delete is omitted: 3-byte* When only one adjustment No. is deleted, this item can be omitted.ンㄆㄇㄆㄓㄆㄏㄆ• If the sum of the adjustment number from which the deletion starts and the number of adjustment settings to deleteexceeds 100, the laser marker returns the negative response.• In the readout response data when no settings are in the selected adjustment number, the adjustment object is readoutas “0” and the subsequent data do not exist.⿎ Example of command settingsCondition: Adjustment No. = 0, Adjustment object = 0 (delete the settings of adjustment number 00)• Setting Transmission data [STX] SRA S 000 [CR]Condition: Adjustment No. = 2, Adjustment object = 0, Number of adjustment settings to delete = 10(delete the settings of the adjustment number 02 to 11)• Setting Transmission data [STX] SRA S 020010 [CR]Condition: Adjustment No. = 2 (if there is no setting for the adjustment number read out)• Readout Transmission data [STX] SRA R 02 [CR]Response data [STX] SRA A 020 [CR]ME-LP-GS-SR-COMP-3
