1163-10-4 Step & repeat settings: SRCSets the condition of “Step & repeat” to mark the same marking contents on multiple locations in one file.ンㄆㄇㄆㄓㄆㄏㄆ• Settings by this command are applied to the object group No. 1000. To the object group No. 1000 the marking dataconverted from LP-400/V files and the data set by LP-400/V compatible command mode belong.• With LP-400/V compatible command mode, the base position of the step & repeat is always set to top left. The settingsof top right, bottom left and bottom right are not available.• With LP-400/V compatible command mode, “bottom left”, “bottom right” and “same as base position” of the counterstating position cannot be set and readout.⿎ Setting request data / response data for readoutStartcode SRC Subcommand[Step & repeat ON/OFF] [Number of rows][Number of columns] [Row step] [Column step]( [X-movement] [Y-movement] ) [Counter behavior]39-byte, 23-byte or 1-byte(Checksum) End codeSub command is “S” for the setting request data and “A” for the response data for readout.⿎ Readout request dataStartcode SRC R (Check sum) End code⿎ Data descriptionName Data length[byte] Data contents RemarksStep & repeatON/OFF 1 “0”: OFF“1”: ON• Specify “1” to enable Step &repeat.• If you specify “0”: OFF, end thedata here. It is not necessary totransmit the subsequent data.• When the step & repeat is setto OFF, the subsequent data donot exist in the response data forreadout.Number of rows 3“001”–“400”• The number of rows indicatesthe making data repeat countfor Y-direction, and the numberof columns indicates that forX-direction.• The upper limit of “Row xColumn” is 10,000.Number of columns 3Row step 7Model Setting range [mm]LP-GS051(-L) “000.000”–“055.000”LP-GS052 “000.000”–“030.000”LP-RC350S “000.000”–“085.000”LP-RF200PLP-RV200P “000.000”–“090.000”These are the interval for placingthe marking data of Step & repeat.The row step is the interval forY-direction while the column step isthat for X-direction.Column step 7ME-LP-GS-SR-COMP-3
