Panasonic LP-GS Series Serial Communication Command Manual

Also see for LP-RF Series: Serial Communication Command Guide Quick reference Operation manual Setup & maintenance guide

Contents

Panasonic LP-GS Series Serial Communication Command Manual Manual pdf 51 page image

513-1 Command ListThe following commands have the compatibility to the commands of the former laser marker model LP-400/LP-V series.ンㄆㄇㄆㄓㄆㄏ㄄ㄆ• Even with the use of LP-400/V compatible command mode, there is a difference in communication processing time andI/O operation timing between LP-400/LP-V series and LP-GS/LP-RC/LP-RF/LP-RV series. After sending the command,always confirm the response data from the laser marker. Do not send the next command before receiving the response.• In some commands the setting range of the parameter differs from the original commands of LP-400/LP-V series. Beforeusing the LP-400/V compatible command mode, confirm the setting parameter in each command.• When install the LP-400/LP-V control program to LP-GS/LP-RC/LP-RF series, confirm the command format and datatransfer sequence to follow the rule described in “2-3 Communication Data Format” (P.31).• To use the command related to the marking quality such as the laser power, confirming the actual marking quality andadjust the settings from the original settings of LP-400/LP-V series.Type Name Code Functions ReferOperation ControlCommand reception permission MKM Controls the reception permission for the settings bycommunication commands.(P.56)Laser pumping LSR Controls the laser pumping ON/OFF. (P.57)Shutter open/close SHT Controls the internal shutter opening/closing. (P.58)Marking trigger MRK Inputs marking trigger (laser radiation startup signal). (P.59)Trigger delay DLY Sets the delay time from trigger input to startingtrigger processing (lasing) operation.(P.60)Guide laser *1 GID Controls radiation of red guide laser for markingposition confirmation.(P.61)Status checking STS Reads out the laser marker status including markingtrigger ready status and error occurrence status.(P.62)Marking end verification MST Enables automatic response of marking result (e.g.normal end, and error occurrence, etc.) at the end ofmarking.(P.63)FileFile selection by number FNO Specifies the file number to change the file. (P.65)File selection by name FNN Specifies the file name to change the file. (P.66)Overwrite file FOR Overwrites the current file onto the laser marker. (P.67)Save file to different number FRG Saves the current file to the specified file number inthe laser marker.(P.67)File name FNM Sets the file name of the number selected. (P.68)ME-LP-GS-SR-COMP-3