221-4 Ethernet1-4-1 Port specifications and connectionTo control the laser marker by Ethernet communication, use an Ethernet port on the controller.ンㄆㄇㄆㄓㄆㄏㄆ• The Ethernet port of this product is compatible with both straight cable and cross cable.• Although the maximum length of cables connecting devices permitted by the standards of Ethernet is 100 m, in order toprevent communication failure due to noise or breakdown of the device, it is recommended to keep the length to 10 m orless.• The Ethernet port can be connected with the following devices simultaneously via a HUB or a router.• PC configuration software• External device for communication command control (PLC and PC for control)• Specific image checkerOn the laser markercontroller sideLP-GS seriesRear of ControllerLP-RC/LP-RF/LP-RV seriesRear of ControllerRJ-45 8-pole connectorAUTO-MDIX compatibleOrange LEDGreen LEDLight up color DescriptionGreen The indicator lights up while connected normally. It blinks during communication.Orange Lights up only when the baud rate is 100 megabits/sec.⿎ LAN cable connectionWhen you connect a LAN cable to the Ethernet port, attachthe ferrite core included to a position as close as possibleto the Ethernet port on the LAN cable controller side.For LP-GS series, if the ferrite core diameter is too largefor the cable width, fix the ferrite core using a tie band.For LP-RC/LP-RF/LP-RV series, turn the LAN cable 3times around the ferrite core as shown in the figure.Ferrite coreTie bandOn the laser markercontroller sideLP-GS seriesLP-RC/LP-RF/LP-RVseriesME-LP-GS-SR-COMP-3
