623-3-7 Status checking: STSReads out the laser marker status, such as marking trigger ready status and error occurrence status.⿎ Readout request dataStartcode STS R (Check sum) End code⿎ Response data for readoutStartcode STS A[Error occurrence status] [Laser pumping status][Command reception status] [Marking trigger ready state][Marking at regular intervals ON/OFF]5-byte(Checksum) End code⿎ Data descriptionName Data length[byte] Data contents RemarksError occurrencestatus 1 “0”: No error“1”: Error occurrenceLaser pumpingstatus 1“0”: Laser pumping OFF“1”: Laser pumping in preparing“2”: Laser pumping completedCommandreception status 1“0”: Command receptionpermission ON“1”: Command receptionpermission OFF• Indicates the command reception permission(MKM command) status. Use this fordetermination of whether various commandscan be transmitted. For details, refer to “2-4Command Reception Condition” (P.42).• When the shutter is closed, the response datais “0”.• When the shutter is opened and no MKMcommand is sent, the response data is “1”.Marking triggerready state 1 “0”: Marking trigger ready OFF“1”: Marking trigger ready ONMarking trigger can be input only with the markingtrigger ready ON.Marking at regularintervals ON/OFF 1“0”: Marking at regular intervalsOFF“1”: Marking at regular intervalsON (Trigger ON state)• When the on-the-fly marking at regularintervals is set, this response data indicatesthe marking trigger ON/OFF state.• When the marking at regular intervals is notused, the response data is always “0”.Total data length 5 The data length is fixed.ンㄆㄇㄆㄓㄆㄏㄆ• “02110” is the response data for status checking with the marking trigger ready ON.ME-LP-GS-SR-COMP-3
