1063-8-2 Graphic object settings (VEC format file) : CDCSets the parameters such as the position and size of the graphic objects (VEC format file).ンㄆㄇㄆㄓㄆㄏㄆ• This command cannot be used for other than VEC format graphic, such as DXF, BMP, JPEG or HPGL etc.• The VEC format is a graphic format converted for the laser marker use.• If the object type set in the specified object number is not the graphic (VEC), the laser marker returns the negativeresponse.⿎ Setting request data / response data for readoutStartcode CDC Subcommand[Object No.] [System reserved value][X-scaling] [Y-scaling] [X-position] [Y-position][Rotation angle] [Laser power correction][Scan speed correction][Pulse cycle correction]LP-GS/LP-RC: 48-byteLP-RF/LP-RV: 51-byte(Checksum) End codeSub command is “S” for the setting request data and “A” for the response data for readout.⿎ Readout request dataStartcode CDC R [Object No.]2-byte(Checksum) End code⿎ Data descriptionName(> Name in LP-400/V)Data length[byte] Data contents RemarksObject No.(> Logo No.) 2 “00”–“15”: Object No. 1200 to 1215System reservedvalue 1 “0”–“9”, “A”–“F” This value does not affect the settingsanymore.X-scaling 8“0010.000”–“1000.000” [%]The correction ratio is calculated usingthe size of the saved graphic data as100%.Y-scaling 8X-position 8“-999.999”–“+999.999” [mm]Specifies the origin coordinate of thegraphic.The graphic origin is the positionspecified when converting the graphicdata into a VEC file.Y-position 8Rotation angle 7 “-180.00”–“+180.00” [°] The rotation center is the origin of thegraphic.Laser powercorrection 3 “000”–“999” [%]The correction ratio is calculated usingthe value set at the laser settings as100%.Scan speedcorrection 3 “001”–“999” [%]Pulse cyclecorrection * (3) “001”–“999” [%]Total data length48or51The data length is fixed.• LP-GS/LP-RC series: 48-byte• LP-RF/LP-RV series: 51-byte* Only for LP-RF series and LP-RV series.ME-LP-GS-SR-COMP-3
