117Name Data length[byte] Data contents RemarksX-movement * (8)“-999.999”–“+999.999” [mm]• Moves the coordinate of the step& repeat data (the all markingdata in the object group No.1000).• When these settings are omitted,“+000.000” is applied to each.• When the step & repeat isOFF, these values are always“+000.000”.Y-movement * (8)Counter behavior 2“00”: Disable “Count individually” • When the counter functionis used in the step & repeat,specify how the counter value isupdated.• When the counter function is notused in the step & repeat, set“00”.• When “Count individually” isdisabled, the all counter valuesare the same in one step &repeat operation.• When “Mark OFF” is set in thestep & repeat fine-adjustmentto a specified data in the step& repeat, the “count Mark OFF”specifies if the counter valueof the unmarked data turns outthe vacant number (ON) or not(OFF).• “Counter starting position”specifies the start position of thecounting in the step & repeat.When “Count individually” is enabled;• With the count direction “Horizontal”Setting Count “MarkOFF” Counter start“10” ON Top left“12” ON Top right“20” OFF Top left“22” OFF Top right• With the count direction “Vertical”Setting Count “MarkOFF” Counter start“11” ON Top left“13” ON Top right“21” OFF Top left“23” OFF Top rightTotal data length39(23)(1)Fixed length.• When X-movement and Y-movement are not omitted: 39-byte• When X-movement and Y-movement are omitted: 23-byte• When step & repeat is OFF: 1-byte• Response data for readout: 39-byte or 1-byte* These items can be omitted when the both values are 0. It is not possible to omit one side of them.⿎ Example of command settingsCondition: Step & repeat ON/OFF = 1,Number of rows = 12, Number of columns = 4, Row step = 4, Column step = 8.5,X-movement = 0, Y-movement =0, Counter behavior = 11• SettingTransmission data [STX] SRC S1012004004.000008.50011or1012004004.000008.500+000.000+000.00011[CR]• Readout Transmission data [STX] SRC R 1 [CR]Response data [STX] SRC A 1012004004.000008.500+000.000+000.00011 [CR]ME-LP-GS-SR-COMP-3
