88ンㄆㄇㄆㄓㄆㄏㄆ• If the object type set in the specified object number is not the bar code/2D code, the laser marker returns the negativeresponse.• Refer to “2-3-5 Character data input method” (P.37) for details on the character input method and character types withinput restrictions.• The characters input by this command are converted to the 2-byte characters automatically.• Depending on the barcode/2D code type, acceptable characters may be restricted to either single-byte characters ordouble-byte characters. In this case, the input characters are automatically converted to the accepted type.• When the code data is set in the several string No., the characters in each string No. are connected together innumerical order without linefeed to create the code data.• When the code data is set in the several string No., the total input characters should be 299 digits or less.• In BCS command you can use GS: 1D (HEX) as “FNC1” and as the separator of the Application identifiers. In the codedata it is shown as “FNC1”. For the response data for readout, it is readout as “GS”.• To set other control codes than GS or FNC1, use BRS command.• If the readout data includes characters that cannot be expressed in ASCII code such as Japanese characters (2-bytecharacter), only these 2-byte characters are read out in shift JIS code.• When the character strings set with the functional character are readout, the setting of the functional character startingwith % are read out. The characters to mark as the functional characters, such as the counter or date and time values,are not read out.• With LP-400/V compatible command mode, you cannot readout the character strings with more than 61-byte length.• With LP-400/V compatible command mode, you cannot set and readout the strings for PDF417, iQR code, QR code forChinese characters (GB/T 18284), and CODE93.• With LP-400/V compatible command mode, you cannot set and readout the strings for QR code with the mode setting“Auto”.⿎ Example of command settingsCondition: Object No. = 0, String No. = 1, Code data = abcd• Setting Transmission data [STX] BCS S 01abcd [CR]• Readout Transmission data [STX] BCS R 01 [CR]Response data [STX] BCS A 01abcd [CR]ME-LP-GS-SR-COMP-3
