64⿎ Automatic response data with response permittedThe following response data transmit normal end or abnormal end at the end of the trigger processing (marking) with themarking end verification response permitted.Startcode MST A [Status]4-byte (Check sum) End code⿎ Data descriptionName Data length[byte] Data contents RemarksStatus 4“0000”: Normal end“E001”–“E999”: Errorcode (abnormal end)• It returns the error code occurred in case of anabnormal end by an error during marking triggerprocessing.• When the warning that does not interrupt themarking operation (E700 to E799) occurs, theresponse data indicates “0000” as the normal end.Total data length 4 The data length is fixed.ンㄆㄇㄆㄓㄆㄏㄆ• Refer to “Error Indication” (P.150) for error codes details.• The automatic response data of the error code will not be transmitted in case of errors occurred when the markingtrigger processing is not in progress.• When on-the-fly marking with multiple triggers or at regular intervals are set, the response data is transmitted at thetiming of each marking completion.• When the marking interval is too short for transmission time of MST command, MST command is not available. In suchcase, check the marking completion by I/O.⿎ Example of command settingsCondition: Response setting = 1• Setting Transmission data [STX] MST S 1 [CR]• Readout Transmission data [STX] MST R [CR]Response data [STX] MST A 1 [CR]Condition: Status = 0000 (normal end)• Response data withresponse permittedResponse data [STX] MST A 0000 [CR]Condition: When the alarm E400 occurred at the marking.Status = E400• Response data withresponse permittedResponse data [STX] MST A E400 [CR]ME-LP-GS-SR-COMP-3
