54Type Name Code Functions ReferLaser settingsLaser power LPW Sets the laser power for the current file. (P.127)Scan speed SSP Sets the scan speed for the current file. (P.128)Laser frequency / pulse cycle MPL Sets the laser frequency (LP-GS/LP-RC) or pulsecycle (LP-RF/LP-RV) for the current file.(P.129)Laser fine tune WTC Fine-tunes lasing quality such as starting and endingpoint by each file.(P.130)Line width / filling line spacing WDC Sets the line width necessary to avoid crossing atmarking intersection and the filling line spacing forbold characters and bar codes.(P.132)Maintenance Laser radiation for measurement SPT Controls “laser radiation for measurement” used tomeasure laser output by a commercially availablepower meter.(P.133)System settings System clock YMD Sets the date and time of the system clock of the lasermarker.(P.134)Command mode RSM Switches the command mode between LP-400/LP-V compatible mode and the standard one. Thiscommand is available when LP-400/V compatibilitysetting is enabled in system settings.(P.135)*1 : Only LP-GS051(-L) type, LP-RC350S, LP-RF series, LP-RV series*2 : Only LP-RC series, LP-RF series, LP-RV seriesンㄆㄇㄆㄓㄆㄏㄆ• The following commands used in LP-400/LP-V series cannot be available with this product.• BBS: Bar code/2D code characters• CDD: DXF logo conditions• FIG: Processing element• LAY: Processing condition• CWL: CW Pulse cycle/duty• MWT: Flying object wait• PWR: Power check• ECR: Error code• ERA: Era year• WKM: Week setting• ENV: I/O environmentME-LP-GS-SR-COMP-3
