46Change settings1. Laser pumping (ON) LSR commandRemote mode OFF2. File selection by number FNO command3. Character object settings STC command4. Character entry MCS or STR command5. File settings ALC command6. Laser settings LPW, SSP command7. Shutter open SHT command8. Status checking STS command12. Command reception permission OFF MKM command13. Shutter close SHT command14. Laser pumping (OFF) LSR command15. Overwrite file FOR command9. Marking trigger MRK command10. Command reception permission ON MKM command11. Change settings Various commandsAfter changing the settings set marking trigger ready ON by“12 Command reception permission OFF”.Marking trigger ready: ONYesYesNo: FinishoperationNo.Remote mode ON⿎ Create marking data and start marking*1 : From sending the laser pumping on request to completion of laser pumping, the following time will be required.• LP-GS series: about 8 to 15 seconds• LP-RC series: about 10 seconds• LP-RF series: about 7 seconds• LP-RV series: about 1 second*2 : Commands from No. 2 to No. 8 above chart can be sent right after turning on laser pumping (without waiting for thelaser pumping completion).*3 : There is a delay time of around 200ms to max. 1 second from sending shutter open/close command for the actualshutter open/close operation time.Besides, with LP-RC series for the first operation of opening shutter after the laser pumping on, it takes around 300msto max. 4 seconds.*3*1, *2ME-LP-GS-SR-COMP-3
