38Command Content to be specified Restrictions on the input charactersLTS Lot character • The ASCII code and Shift JIS code can be mixed.• Control codes cannot be used.• Functional characters cannot be used.• No line feed is allowed.RKS Registered characterstringsFNN File nameFNM File nameCDF Graphic file nameンㄆㄇㄆㄓㄆㄏㄆ• For details of the character codes, refer to “Character Code Table” (P.163).• The one-byte and two-byte represent the data input method, and there is no distinction between the one-byte and two-byte for marking characters.• For the input character to Bar code/2D code object, depending on the code type, the acceptable character type isrestricted to either one-byte or two-byte character. In this case, the input character is converted automatically to theacceptable type.• If the data contains any characters which belong to the non-supported character code, it cannot be set or read out.• Characters in TrueType object cannot be set with communication command.• With LP-400/V compatible command mode, you cannot set the characters of the character objects other than thereference list type.Example of character input• To input “ABCD”Input using the ASCII codes*: 41 42 43 44Input using the Shift JIS codes*: 8260 8261 8262 8263* Spaces in the example above are not included in the input data.ME-LP-GS-SR-COMP-3
