394.6.3.c Enable/Disable Individual TrapOn the SNMP Trap Receiver Configuration Menu screen, pressing "D" opensthe Enable/Disable Individual Trap Menu screen, as shown in Fig. 4-6-7. Onthis screen, you can set the trap sending settings.Fig. 4-6-7 Enable/Disable Individual TrapScreen DescriptionSNMPAuthenticationFailureDisplays the trap sending settings for an SNMP authentication failure.Enabled Enables the trap sending.Disabled Disables the trap sending. (Factory default setting)Enabled LinkUp/Down PortDisplays the port number to which a trap is sent, when its link statuschanges. All ports are assigned in factory default setting.PoE TrapControlDisplays the PoE trap control settings.Enabled Enables the trap sending.Disabled Disables the trap sending. (Factory default setting)TemperatureTrap ControlDisplays the trap sending settings when the internal temperature isabove or below the preset temperature.Enabled Enables the trap sending.Disabled Disables the trap sending. (Factory default setting)TemperatureThresholdDisplays the threshold temperature value to send the trap.The factory default setting is 50 degress C.FAN Failure Displays the trap sending settings for an internal fan failure.Enabled Enables the trap sending. (Factory default setting)Disabled Disables the trap sending.PN23249K/PN23249A Local Management SystemSNMP Trap Receiver Configuration -> Enable/Disable Individual Trap MenuSNMP Authentication Failure : DisabledEnable Link Up/Down Port: 1-26PoE Trap Control: EnabledTemperature Trap Control: DisabledTemperature Threshold: 50 degree(s) CelsiusFAN Failure: Enabled-------------------------------- -----------------------------------Enable/Disable [A]uth Fail TrapAdd Link Up/Down Trap [P]orts[D]elete Link Up/Down Trap PortsEnable/Disable Po[E] TrapEnable/Disable [T]emperature Trap[S]et Temperature ThresholdEnable/Disable [F]AN Fail Trap[Q]uit to previous menuCommand>Enter the character in square brackets to select option
