18644..77..1111.. PPoowweerr OOvveerr EEtthheerrnneett CCoonnffiigguurraattiioonnOn the Advanced Switch Configuration Menu, pressing "P" opens the PowerOver Ethernet Configuration Menu as shown in Fig. 4-7-58. You canconfigure IEEE 802.3af power supply.Fig. 4-7-58 PoE configurationAvailable commands are listed below.P Configure PoE for each port.Press "P." The PoE Port Configuration Menu opens. Refer to 4.7.11.a.G Configure PoE for the entire Switching Hub.Press "G." The PoE Global Configuration Menu opens. Refer to 4.7.11.b.Q Return to the previous menu.Note: This Switching Hub can supply a maximum of 175 W in total to IEEE802.3af power devices. It can supply a maximum of 15.4 W to eachport in accordance with the IEEE 802.3af standard. However, ensurethat the total power required by terminals connected to ports 1through 24 will not exceed 175 W. If this limit is exceeded, the Statusfield displays "Overload" as shown in 4.7.11.a, which means thatpower supply is impossible.PN23249K/PN23249A Local Management SystemAdvanced Switch Configuration -> Power Over Ethernet Configuration MenuPoE [P]ort ConfigurationPoE [G]lobal Configuration[Q]uit to previous menuCommand>Enter the character in square brackets to select option
